xingyuan rubber and plastic < a href = "http://www.globalgd.com/" > < strong > mechanical CE certification < / strong > < / a > < / span > < / p >

The following machinery can provide CE certification and testing.

Injection molding machine CE certification, blow molding machine CE certification, extrusion machine CE certification, compression and die casting mold machine CE certification, die cutting machine CE certification, grinder CE certification, reactive molding machine CE certification, plastic molding machine CE certification, plastic injection molding machine CE certification, plastic hollow molding machine CE certification, straw coal molding machine CE certification, carbon powder molding machine C E Certification, sealing machine CE certification, plastic welding machine CE certification, plastic granulator CE certification, foam granulator CE certification … …

In the design of the controller should pay attention to the following rubber and plastic machinery CE certification

Control device must:

& ndash; — Clearly visible and easily identifiable, with appropriate marking if necessary;

& ndash; — The installation position is suitable for safe operation, will not delay and waste time, and clear;

& ndash; — In design, it can ensure that the movement of the controller is consistent with its effect;

& ndash; — If necessary, except for some controllers, such as emergency shutdown, remote control training console, are installed outside the danger area;

& ndash; — The installation position ensures that its operation will not cause additional hazards;

& ndash; — Designed or protected in such a way that the desired result will not occur if the hazard is involved, as long as the operation is not intentional;

& ndash; — Able to withstand predictable stress states; Special attention must be paid to the fact that the emergency stop device may be placed under considerable stress.

When a controller is designed and built to perform several different actions, that is, not one in pair (such as a keyboard, etc.), the actions it performs must be clearly displayed and confirmed when necessary.

The controller must be able to be configured according to ergonomic principles so that its layout, travel and control operations and other functions match the actions it performs. The limitations of personal protection equipment that must be used or expected to be used (such as work shoes, gloves, etc.) must be considered.

Indicating devices (such as indicator panels, signal lights, etc.) must be installed on the mechanical equipment according to the requirements of the operation. The operator must be able to read these indicators and signals from the console.

The operator must be able to ensure from the main console that there are no exposed personnel in the hazardous area.